Micro SD Card is included, and loaded with an Example Config.txt file.
Supports both 160 baud ALDL, and 8192baud ALDL (5v).
Designed for Aussie Delco ECU compatibility (VN/VP/VR/N13/Astra/Opel/Vauxhall etc). Stock or running OSE12P or OSE11P.
Fully customisable display when used with OSE11/12P. PWM outputs to control actuators, boost solenoids, water/meth injection, etc... (micro SD card required when used with 11/12p).
Display parameters can be configured and can change depending on inputs in real time. E.G. display only BOOST and AFR when positive manifold pressure, Warning display when CLT or IAT excessive, Boost excessive etc. PWM output can be linked to any sensor input and set up using a lookup table.
User Manual HERE
Latest Firmware HERE (v0.02)
Example CONFIG.TXT file HERE
Forum Build Log HERE
Note: LCD is designed to be powered from the ECU's 5v supply (Available at the ECU connector/loom). It can operate at 12v (ONLY IN 160 BAUD MODE!) though may overheat in the warmer months. 5V operation is strongly recommended. 5v only for 8192 Baud.
Soldering IS required for installing this display. As this product is sold at cost-price, no customer support is given - refer to the forum for further information. Please consider this before purchasing.